GLAST / LAT > DAQ and FSW > FSW > Doxygen Index> LIM / V1-22-3 > lim / linux-gcc
Public Attributes | |
unsigned int | key |
int | disp_install |
ITC_TaskID | lim_tid |
LIM_Mode * | mode_p |
LIM_Pkt_Send * | cal_start_p |
LIM_Pkt_Send * | cal_abort_p |
LIM_Pkt_Send * | phys_start_p |
LIM_Pkt_Send * | phys_stop_p |
LIM_Pkt_Send * | phys_config_p |
LIM_Pkt_Send * | gbm_calcinfo_p |
LIM_Pkt_Send * | gbm_closeout_p |
LIM_Pkt_Send * | gbm_repoint_p |
Lim_Apid | apid [10] |
Lim_Command | cmd [20] |
Information about intercepted APIDs. Each entry describes a separate APID. Unused entries are identified with an APID value of zero.
Referenced by lim_intercept_apid(), and LIM_intercept_delete().
Pointer to packet sending object to use with a Calibration-Abort command.
Referenced by LIM_intercept_cal(), and LIM_intercept_new().
Pointer to packet sending object to use with a Calibration-Start command.
Referenced by LIM_intercept_cal(), and LIM_intercept_new().
Information about intercepted commands. Each entry describes a separate command. Unused entries are identified with an apid_p value of NULL.
Referenced by lim_intercept_command(), and lim_intercept_dispatch().
Nonzero value indicates that the special LIM CMD-X queue command dispatch function is installed.
Referenced by LIM_intercept_delete(), and LIM_intercept_new().
Pointer to packet sending object to use with a GBM-Calcinfo command.
Referenced by LIM_intercept_gbm(), and LIM_intercept_new().
Pointer to packet sending object to use with a GBM-Closeout command.
Referenced by LIM_intercept_gbm(), and LIM_intercept_new().
Pointer to packet sending object to use with a GBM-Repoint command.
Referenced by LIM_intercept_gbm(), and LIM_intercept_new().
unsigned int _LIM_Intercept::key |
Key value that is set to LIM_INTERCEPT_VALID_KEY when the intercept object state is valid.
Referenced by lim_intercept_check(), LIM_intercept_delete(), and LIM_intercept_new().
ITC_TaskID _LIM_Intercept::lim_tid |
ID of the LIM task.
Referenced by lim_intercept_apid(), LIM_intercept_delete(), and LIM_intercept_new().
Pointer to mode control object.
Referenced by lim_intercept_dispatch(), and LIM_intercept_new().
Pointer to packet sending object to use with a Physics-Configure command.
Referenced by LIM_intercept_new(), LIM_intercept_physics(), and LIM_intercept_physics_idle().
Pointer to packet sending object to use with a Physics-Start command.
Referenced by LIM_intercept_new(), and LIM_intercept_physics().
Pointer to packet sending object to use with a Physics-Stop command.
Referenced by LIM_intercept_new(), and LIM_intercept_physics().